Vpacket Hotwire 5100 Guia do Utilizador descarregar pdf (Página 14)

Installing and Connecting the Card

2-2

5100-A2-GB20-00

November 1996

In addition to Steps 1–9, a HotWire DSL CP card must be installed in a

customer’s PC (as described in the

HotWire 5100 DSL Access System Customer

Premises User’s Guide)

and a DSL line must be provisioned by the POTS

provider to make a DSL link operational.

If you are also responsible for installing the POTS splitter at the customer

premises, refer to Appendix B,

Installing POTS Splitter at Customer Premises

Setting I/O Base Address

The DIP switch bank SW1 shown in the following figure is used to assign the

card’s I/O base address.

496-14980

678

12345

To help you keep track of your configuration, use the following configuration table

to record the CO PC slot in which you have installed a CO card. The cards can

occupy any available slot.

The channel numbers (0–17) are tied to I/O base addresses as shown in the

configuration table. Use these numbers to identify a card when using the HotWire

DSL Central Management Utility.

NOTE:

Ensure that the I/O base addresses used by the CO cards do not conflict with

the I/O base addresses of any other cards in the CO PC.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 58 59

Sem comentários

Vpacket Hotwire 5100 Guia do Utilizador Página 14